0
Owner's of the Avanti Beverage Dispenser BD7000 gave it a score of 0 out of 5. Here's how the scores stacked up:
13
Connecting the beer tower to coupler
Make sure the washer is properly inserted into the wing nut.
Place wing nut into the top of the coupler turning until tight.
How To Tap A Keg Of Beer
Make sure the beer tower faucet is in the closed position.
Pull tapping handle out and press downward until it locks into position. (See Figure 8) The keg is
now tapped.
Opening The CO
2
Cylinder Main Valve
Before doing that, make sure the secondary shut-off valve is closed, as shown in figure 9. To
open the main CO
2
cylinder valve, slowly turn the main valve counter-clockwise until fully open.
Notice the needle on the gauge start to climb.
Adjusting The CO
2
Regulator
The gauge monitors low internal keg pressure and should be adjusted to read between 10-12 psi.
(See Figure 10)
In order to do that:
1. Release adjustment lock nut marked 2.
2. Using a flat screwdriver, turn regulator screw marked 3. If increased low pressure is sought,
rotate screw clockwise. By rotating it counter clockwise, low pressure will be decreased when
the required operating pressure is attained, retighten lock nut 2.
Open secondary shut off valve to let CO
2
flow into the keg.
Installation of Protective Plate
This plate should always be installed when the keg is in place to protect against unnecessary
damage to the floor of the cabinet liner.
Installation of the Beer Keg
Position the beer keg directly in front of the open door. Using keg handles only, carefully lift the
beer keg. (See Figure 3)
To place the beer keg inside the cabinet, brace your knees behind the beer keg. Lift the front of
the keg just enough so the front edge of the keg is resting on the front edge of the Beer Dispenser
bottom cabinet. (See Figure 4)
Grasp the keg handles and slide it all the way into the cabinet.
Figure 3 Figure 4
Find Your Products By Category
Please Login
