Whirlpool Convection Oven GH7208XR User Manual

4.1

Out of 5 Ratings

Owner's of the Whirlpool Convection Oven GH7208XR gave it a score of 4.1 out of 5. Here's how the scores stacked up:

  • Reliability

    4.2 out of 5

  • Durability

    4.0 out of 5

  • Maintenance

    4.2 out of 5

  • Performance

    4.0 out of 5

  • Ease of Use

    4.0 out of 5
of 36
 
33
Replacing Oven Light
The oven light is a 10W low-voltage halogen capsule bulb. It will
automatically come on when the door is opened and when the
oven is operating. See “Assistance or Service” section to reorder.
You will need a TORX
®†
T10
screwdriver to remove the bulb cover.
To Replace:
1. Unplug oven or disconnect power.
2. Gently pull vent screen rings and lift the screen off the
exhaust vent at the top of the oven.
If using recirculating exhaust venting, skip Step 3.
3. For wall or roof venting, remove the vent deflector by
removing the mounting screws (1 from each end), and lifting
out the vent deflector.
4. Remove the bulb cover mounting screw, then lift cover.
A. Bulb cover mounting screw
5. Remove the burned-out bulb by squeezing the wire clip
together, pulling to the right and lifting.
6. Replace bulb, using tissue or wearing clean cotton gloves to
handle bulb. Do not touch bulb with bare fingers.
7. Close bulb cover, and fasten with screw.
If using recirculating exhaust venting, skip Step 8.
8. For wall or roof venting, replace the vent deflector removed in
Step 3.
9. Replace vent screen.
10. Plug in oven or reconnect power.
A.Vent screen
B.Rings
C.Bulb cover (under screen)
A.Bulb cover
B.Vent deflector
C.Vent deflector mounting screws (2)
†®TORX is a registered trademark of Textron Innovations Inc.
A B C
A B C
A

   Find Your Products By Category