0
Owner's of the Viking Gas Grill VGBQ5304RE1L gave it a score of 0 out of 5. Here's how the scores stacked up:
29
Product Care
28
Product Care
Cleaning and Maintenance
Infrared Rotisserie Burner
Special care is not required for the infrared rotisserie burner. It
is designed as a self-contained unit. Do not attempt to clean it. Its own
operation burns off any impurities which may condense on it.
Individual part cleaning chart
Part
What to use How to clean
Stainless steel* Mild detergent and warm
water or stainless steel
cleaner
Wipe with soft cloth or
sponge. Use stainless steel
cleaner to remove fingerprints
and smudges. Rinse and dry
thoroughly.
Porcelain parts
(Grates)
Mild detergent and warm
water or nonabrasive
household cleaners.
Wipe with soft cloth or
sponge. Rinse and dry
thoroughly. For stubborn
spots, occasionally use a
non-caustic oven cleaner
(fume free).
Flavor Plates Mild detergent and
warm water or stainless
steel cleaner
Soak in warm water and mild
detergent. For stubborn
spots, scrub with stainless or
brass bristle BBQ brush. Wipe
down with heavy-duty cloth or
sponge. Dry thoroughly.
Control knobs Mild detergent and
warm water or
nonabrasive household
cleaners. Do not soak.
Wipe with soft cloth or
sponge. Rinse and dry
thoroughly.
Painted parts
(Canopy)
Mild detergent and warm
water or nonabrasive
household cleaners
Wipe with soft cloth or
sponge. Rinse and dry
thoroughly.
*NOTE: Under rare conditions, such as an extremely salty environment, small
amounts of rust may accumulate on stainless steel parts. These small amounts
of surface rust can easily be removed by applying Soft Scrub® Gel to a damp
sponge and wiping with the stainless steel grain. It is important to make sure
you wipe with the grain for the most efficient removal of surface rust.
Cleaning and Maintenance
Battery Replacement
Each T-Series grill is equipped with a battery for the electronic
ignition. The 30”W. models only have one battery located
under the left hand side of the control panel. All other models
have two batteries located under each end of the control
panel. The battery locations are shown on the control panel.
To replace the battery:
1. Slide out drip tray.
2. Locate round black cap, which is inside the burner box
under the battery symbol on the control panel.
3. Unscrew cap. Battery is snapped in the cap.
4. Replace the battery by connecting corresponding post to
post inside burner box.
5. Snap cap on battery and screw back into slot underneath
control panel.
Battery
cap
BatteryBatteryBattery
NOTE: Round black cap that holds
battery is located underneath
control panel and behind drip tray.
Find Your Products By Category
Please Login
