0
Owner's of the KitchenAid Gas Grill KBNS271TSS gave it a score of 0 out of 5. Here's how the scores stacked up:
23
6. If flame is yellow (not enough air), turn air shutter adjustment
screw counterclockwise.
If flame is noisy or lifts away from burner (too much air), turn
air shutter adjustment screw clockwise.
Adjustment should be made clockwise or counterclockwise
from ¹⁄₈" (3.2 mm) to ¹⁄₄" (6.4 mm).
7. Replace gas burner, sear plates and grates.
8. Light grill using information in the “Outdoor Grill Use” section.
See “Burner Flame Characteristics.”
Low Flame Adjustment
If flame goes out on the “LO” setting, the low flame setting must
be adjusted.
1. Turn off the valve and wait until grill and burners are cool.
2. Remove grill grates and sear plates.
3. Light grill using information in the “Outdoor Grill Use” section.
4. Turn burner to its lowest setting and remove knob.
5. Hold valve stem with pliers and insert a small flat-blade
screwdriver into the shaft.
6. Watch the flame and slowly turn the screwdriver
counterclockwise.
7. Adjust flame to minimum stable flame.
8. Replace the control knob and turn off the burner.
9. Repeat steps 3 through 8 for each burner if needed.
10. Replace the sear plates and grates after the burners have
cooled.
OUTDOOR GRILL USE
This manual covers several different models. The grill you have purchased may have some or all of the features listed. The locations and
appearances of the features shown here may not match those of your model.
Control Panel
A. Air shutter adjustment screw
A
A.Valve stem
B.Small flat-blade screwdriver
C. Pliers
A
B
C
A. Left rotisserie burner control knob
B.Left grill burner control knob
C. Center grill burner control knob
D. Right grill burner control knob
E. Electronic grill display (on some models)
Light switch button (on some models)
F. Sear burner control knob
G. Right rotisserie burner control knob
A
B
C D
E
F
G
Find Your Products By Category
Please Login
