4.8
Owner's of the Bosch Appliances Washer/Dryer Bosch Appliances Washer/Dryer gave it a score of 4.8 out of 5. Here's how the scores stacked up:
24
Liquid detergent dispenser
To measure liquid detergent:
1.
Pull out the detergent drawer. Press down on the insert
and remove the drawer completely.
2.
Push the liquid detergent dispenser forward.
3.
Insert the drawer again.
NOTICE: Do not use the liquid detergent dispenser with
gel-type detergents and powdered detergents or for
cycles with pre-wash and selected "Finish at" time.
Starting the cycle
Press the Start/Pause button Indicator lamp lights up
and the cycle starts.
NOTICE: If you want to protect the cycle against
inadvertent adjustment, select the child lock.
~ Child lock; Page 24
During the cycle, the display field indicates the "Finish at"
time and, after starting the washing cycle, the cycle
duration and the symbols for the cycle progress.
~ Display field; Page 16
Child lock
You can secure the washer against inadvertent changing
of the set functions. To do this, activate the child lock
after cycle start.
To Activate/Deactivate, press Start/Pause for approx. 5
seconds. In the display field, you will see the D symbol.
▯ D lit steady: The child lock is active.
▯ D blinking: The child lock is active and the cycle
selector has been adjusted. To prevent a cycle
interruption, set the cycle selector back to the initial
cycle. The symbol lights up again.
NOTICE: The child lock can remain activated until the
next cycle start even after switching the machine off.
Then you must deactivate the child lock before cycle
start and if necessary activate it again after cycle start.
Selecting a different cycle
If you have inadvertently started the wrong cycle, you can
change this as follows:
1.
Press Start/Pause.
2.
Select another cycle.
3.
Press Start/Pause. The new cycle starts from the
beginning.
Pausing/Continuing the cycle
e.g. for soaking ~ Soaking; Page 20
Press Start/Pause. -
¿ - appears on the display panel;
washing machine door cannot be opened. To continue
the cycle, press Start/Pause.
Cancel cycle
For cycles with a high temperature:
1.
Press Start/Pause.
2.
Cool the laundry off: Select Rinse.
3.
Press Start/Pause.
For cycles with a low temperature:
1.
Press Start/Pause.
2.
Select Spin/Drain.
3.
Press Start/Pause.
Cycle end with rinse stop
Appears in the display field – – – and the indicator lamp
on the Start/Pause button blinks.
In order to exit the cycle, set the cycle selector to Spin/
Drain or select a spin speed range, then press the Start/
Pause button.
Cycle end
End appears in the display field and the Start/Pause
button indicator lamp is off.
If the cycle status sequence Wash is also flashing in the
display field, the washer has detected too much foam
during the washing cycle and it has then automatically
switched on a rinse to remove the foam.
NOTICE: Use less detergent the next time you run the
washer with the same load.
Removing laundry/switching the
appliance off
1.
Open the front door of the washer and remove the
laundry.
2.
Turn the cycle selector to the Off position. Appliance is
switched off.
3.
Turn off the water tap.
NOTICES
▯ Do not leave any laundry in the drum. It can shrink or
be discolored by the next laundry.
▯ Remove any remaining items from the drum and
rubber gasket.
Find Your Products By Category
Please Login
