Alpine Car Stereo System CDE-121 User Manual

1.2

Out of 1 Ratings

Owner's of the Alpine Car Stereo System CDE-121 gave it a score of 1.2 out of 5. Here's how the scores stacked up:

  • Reliability

    5.0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    1.0 out of 5
of 93
 
29-EN
01GB05CDE121.fm
ALPINE CDE-121 68-16909Z79-A (EN)
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your
power antenna, if applicable.
• This lead should be used only for controlling the
vehicle’s power antenna. Do not use this lead to turn on
an amplifier or a signal processor, etc.
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of
your amplifier or signal processor.
Audio Interrupt In Lead (Pink/Black)
Not used for this unit.
Illumination Lead (Orange)
Not used for this unit.
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the
vehicle’s fuse box or another unused power
source which provides (+)12V only when the
ignition is turned on or in the accessory position.
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the
vehicle’s battery.
Ground Lead (Black)
Connect this lead to a good chassis ground on
the vehicle. Make sure the connection is made to
bare metal and is securely fastened using the
sheet metal screw provided.
Power Supply Connector
Right Front (+) Speaker Output Lead (Gray)
Right Front (–) Speaker Output Lead (Gray/
Black)
Right Rear (–) Speaker Output Lead (Violet/
Black)
Right Rear (+) Speaker Output Lead (Violet)
Left Rear (+) Speaker Output Lead (Green)
Left Rear (–) Speaker Output Lead (Green/
Black)
Left Front (–) Speaker Output Lead (White/
Black)
Left Front (+) Speaker Output Lead (White)
Radio Antenna Receptacle
Fuse Holder (10A)
Subwoofer
Output RCA Connectors
RCA Extension Cable (sold separately)
RED is right and WHITE is left.
Front AUX Input Terminal
This terminal allows for input of audio from an
external device (such as a portable player),
using a commercially-available converter cable.
USB Port
Connect Flash memory or iPod/iPhone (sold
separately)
Interface cable for iPod (supplied)
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car
chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries
various noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
01GB00CDE121.book Page 29 Monday, December 13, 2010 2:03 PM

   Find Your Products By Category