4.0

Out of 1 Ratings

Owner's of the Sharp Microwave Oven R-930CS gave it a score of 4.0 out of 5. Here's how the scores stacked up:
  • Reliability

    4.0 out of 5
  • Durability

    4.0 out of 5
  • Maintenance

    4.0 out of 5
  • Performance

    4.0 out of 5
  • Ease of Use

    4.0 out of 5
of 32
 
A31679 R-930AK/AW/CS O/M
3
TINSEB008WRRZ-D31 SEC R-930AK/AW/CS
Applicable G.E.
Wall Ovens
JKP18BW
JKP18WW
JKP18AW
ZET-837SYSS
Unpacking and Examining Your Oven
Remove:
1. all packing materials from inside the oven cavity.
Read enclosures and SAVE the Operation
Manual. DO NOT REMOVE AND THROW OUT
THE WAVE GUIDE COVER.
2. the feature sticker from the outside of the door,
if there is one.
Check the oven for any damage, such as misaligned
or bent door, damaged door seals and sealing
surfaces, broken or loose door hinges and latches
and dents inside the cavity or on the door. If there is
any damage, do not operate the oven and contact
your dealer or SHARP AUTHORIZED SERVICER.
Choosing a Location for Your Oven
You will use your oven frequently so plan its location
for ease of use. The oven must be placed on a
countertop which is a minimum of 36 inches from the
floor. Allow at least 2 inches on the sides, top and at
the rear of the oven for air circulation. Be sure to
position oven so that the rear cannot be touched
inadvertently.
Your oven can be built into a cabinet or wall by itself
or above any General Electric wall oven using Sharps
Built-in Kit listed below. It cannot be built in above
conventional gas or electric ranges or any other wall
ovens.
Oven Cavity
Door Seals and
Sealing Surfaces
Hinges
Latches
Sketch-1
MIN.
1 / "
2
1
GE Electric Wall
oven.
MIN.
36"
INSTALLATION INSTRUCTIONS
Sharp Microwave
Oven Model
R-930AK
R-930AW
R-930CS
Applicable
Built-in kits
RK-66A
RK-66WB
RK-93S27
RK-93S30
Note for R-930CS:
Select the Built-in kit RK-93S27 or RK-93S30 depending on the desired finished width. The RK-93S27 is for
a 27 inch and the RK-93S30 is for a 30 inch finished width. The RK-93S27 cannot be used with any of the G.E.
wall ovens.
See Sketch 1 for proper location when building in above the specified G.E. wall ovens. Carefully follow both
the G.E. wall oven installation instructions and Sharps Built-in Kit instructions. Be sure that the clearance of
the floor between the wall oven and the microwave oven is minimum of 1
1
/2 inches.
Ordering the Built-in Kits.
If your dealer does not stock the kit, it can be ordered directly from the Sharp Accessories and Supplies Center.
Have your credit card number available and call toll-free: 1-800-642-2122 for ordering the kit to be sent to your
address.
The kit includes ducts and finish trim strips and easy-to-follow instructions for installation as well as the location
of the power supply.
P.01-P.11 03.5.12, 5:32 PM3