0
Owner's of the Bissell Vacuum Cleaner 4122 gave it a score of 0 out of 5. Here's how the scores stacked up:
www.bissell.com 800.237.7691
Maintenance and care
www.bissell.com 800.237.7691
8
Filters protect the motor from dirt and dust
particles. Use only BISSELL replacement filters
in your Zing Bagged canister vacuum.
1. Turn the power OFF ( ). Unplug the
vacuum from electrical outlet.
2. Disconnect the flex hose by turning the
hose cuff counterclockwise.
3. To locate the pre-motor filter, open the dust
bag compartment by lifting up on the latch
located underneath the carry handle. Remove
the dust bag from the dust bag folder.
4. Locate the circular pre-motor filter in the dust
bag compartment. To remove the pre-motor
filter, first remove the clip located in the
center of the pre-motor filter. This clip holds
the filter in-place during use. Do not remove
the pre-motor filter without first removing the
pre-motor filter clip.
5. After removing the pre-motor filter clip,
remove the circular pre-motor filter and clean
by hand washing in warm water. A mild
detergent may be used if desired. Allow the
filter to air dry completely before replacing.
6. Position the pre-motor filter inside the dust
bag compartment. With the filter in-place,
insert the pre-motor filter clip in the hole
located in the center of the filter. Replace
the vacuum bag per the instructions on
page 7. Close the dust bag compartment
door and reconnect the flex hose.
7. To locate the post-motor filter, first locate the
vent underneath the Variable Suction Power
Control knob and next to the power switch
and cord rewind button. Remove the vent
grate by pushing up on the grooves at the
bottom of the grate.
8. With the vent grate removed, locate the
post-motor foam filter attached to the grate.
Remove the foam filter and clean by hand
washing in warm water. A mild detergent
may be used if desired. Allow the filter to
air dry completely before replacing.
9. Replace the post-motor foam filter in the vent
grate and attach the vent grate to the vacuum.
NOTICE:
This product is intended for house-
hold use only and not for commer-
cial or industrial use. Vacuuming
of dust from products like plaster,
concrete or ashes will damage the
motor and void the warranty.
Tip:
For maximum cleaning
performance, check the
filters often and clean or
replace if necessary.
WARNING:
Do not operate cleaner
with damp or wet filters or
without all filters in place.
Cleaning and replacing the pre-motor and post-motor filter
Pre-Motor
Filter
Post-Motor
Filter
4.
7.
Find Your Products By Category
Please Login
