0
Owner's of the AT&T Conference Phone AT&T Corded Phone gave it a score of 0 out of 5. Here's how the scores stacked up:
6
Getting started
Plug one end of the coiled handset cord into the handset jack on the left
side of the telephone base. Plug the other end into the jack at the bottom of
the handset.
1.
Install the telephone base as shown below. If you subscribe to high-speed
Internet service (DSL - digital subscriber line) through your telephone line, you
must install a DSL filter between the telephone line cord and the telephone
wall jack. The filter prevents noise and caller ID problems caused by DSL
interference. Please contact your DSL service provider for more information
about DSL filters.
Telephone installation
Plug one end of the telephone line cord into the TEL LINE jack on the back
of the telephone base. Plug the other end of the telephone line cord into a
telephone wall jack or a DSL filter.
2.
Lift the handset or press SPEAKER to check for a dial tone.
Adjust the angle of the tilt display to reach maximum visibility.
3.
4.
Handset
Coiled handset cord
A DSL filter (not included)
is required if you have DSL
high-speed Internet service.
The DSL filter must be
plugged into the telephone
wall jack.
Telephone wall jack
Find Your Products By Category
Please Login
